Engine Oil
- Make sure vehicle is on a flat leveled surface
- Start the engine and allow it to reach the normal operating temperature
- Pull the dipstick out, wipe it clean and re-insert it fully
- The level should be between the 2 dots( high and low)
Engine Coolant Level
Never attempt to remove the radiator cap whilst the engine is operating
- The coolant level should be between F (MAX) and L (MIN) marks on the side of the coolant auxiliary tank, when the engine is cool
- If the coolant level is low, bring the level to F (MAX), but do not overfill Checking The Brake Fluid Level
Checking The Brake Fluid Level
- Be sure the vehicle is on flat ground
- The level of the brake and clutch fluid should be between MAX and MIN marks on the fluid container. Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid contamination
- In case of spongy or hard or low brake efficiency, please contact the nearest authorised workshop
Checking The Washer Fluid Level
- Windshield washer fluid container contains a translucent liquid
- Do not add detergent or solvent in the windshield washing water
Power Steering Fluid
- The level of the power steering fluid shall be between the MIN and MAX marks on the sides of the power steering fluid containe
- If level falls below MIN, please add the recommended fluid
- Do not start the engine without oil, in power steering system